This set of -10 AN Stainless Steel Braided Oil Cooler Lines is specifically designed to function with multiple engine installations in a 2nd Generation RX-7; 13B, 13BT, 13B-RE and 13B-REW.
The kit includes both SS Oil Cooler Lines, four AN to Metric adapter fittings and Metric Dowty Seals.
NOTE: Installation of this kit requires relocation of A/C lines if applicable.
-10AN to Metric Straight Adapter, Black Aluminum
Used on FC and RX-8 OEM Oil coolers.
-10 AN 90 Degree Hose End, Black Aluminum
-10 AN 45 Degree Hose End, Black Aluminum
Stainless Braided Flex Hose with synthetic rubber inner liner.
Dual Oil Coolers recommend purchasing 15ft.
Single Oil Cooler requires 6ft.
Metric Port Plug; Size: M18 x 1.5, includes Crush Washer
Used on FC Rear Iron when installing Banzai Racing Billet Oil Filter Pedestal and Stainless Oil Cooler lines or to block port on pedestal when using OEM oil cooler lines.
We designed the Banzai Racing Billet Aluminum Oil Filter Pedestal as a direct replacement for the OEM FD & Cosmo 13B-RE/20B pedestal. The Pedestal is designed to accommodate both FD & FC oil filters and is 4mm shorter than FD OEM pedestal to allow for taller filters. It has one 1/4" NPT & three 1/8" NPT ports for sending units or loop lines. Our pedestal uses the same 18mm x 1.5 thread to allow the factory banjo bolt to be installed. It can also be used on all FC 13B motors with the addition of an 18mm plug.
The oil filter pedestals are available in anodized Black, with limited editions available in Red, Blue, Purple, Gold & Aluminum.
The pedestal kit comes with:1 x Billet Oil Filter Pedestal2 x Stainless Studs2 x Viton O-rings2 x Serrated Nuts3 x 1/8 NPT Plugs1 x 1/4 NPT Plug
